【Echo Tech】 Don’t do “this” on ultrasonic cutter ZO series.
Ultrasonic cutter suddenly stop activation.
Have you ever experience that situation?
You might doing something unconsciously, that you shouldn’t do for ultrasonic cutter.
Ultrasonic cutter ZO series
・Leave contamination inside hand piece horn.
Please keep clean inside hand piece horn, doing maintenance once in a week at least.
(If you are using cutter longer, please keep clean within short terms.)
This is one of major trouble we used to hear from user that their unit stop working.
Wipe contamination inside horn with Maintenance set SB01 or cotton swab.
・Applying too much power on hand piece.
When you cut hard material, aren’t you applying power too much on hand piece?
ZO-91 and ZO-95 has installed TAF circuit, that enhances blades sharpness when it detects power applied on blade. This function is for saving transducer’s extra power and prevent its consuming. Conversely, transducer might consumes rapidly when it applied too much power.
・Using blade not supplied from Echo Tech.
Please use blades only which we supplied.
・Cut materials which contains water.
For example when you cut food, animal, organ, any of materials which contains water, it might invade in handpiece. Please do not cut those materials.
ZO-91 model
・Using High mode too much.
Because High mode use much power, transducer might consumes rapidly.
ZO-95 model
・Using S-High mode too much.
Because S-High mode use much power, transducer might consumes rapidly.
・Connect Foot switch ZH801 before unit turned ON.
Unit will not activate when the foot switch has connected before the unit turned ON.
Foot switch ZH801
・Using “Grinding stone bar” within ZO-95 hand piece.
Basically, ZO-95 could not use “Grinding stone bar”, due to bar’s length and unit power.
When it has been used, grinding stone might burn or consumes rapidly and lead trouble.
To use grinding stone bar, please get ZO-91 model or ZO-91 model’s handpiece with ZO-95 connector.
ZH55~ZH63 Grinding stone bar.
・Using replacement blades that are not corresponded to ZO-95 model or any power modes.
Please check Adaption list mentioned on catalog.
Ultrasonic cutter ZO-91 ZO-95 English catalog
※This catalog is a version published in May, 2021. Please notice that text on catalog might be old if there are some changes from May, 2021.
Make contact us every time.
We will keep update this page, but it might not mentioned your defect.
When your unit shows any defects, please make contact us anytime.
We are every time here to help your unit trouble.
Any of questions or comments are also acceptable!
worldinfo@us-dolphin.co.jp