MENU
HOME > Blog > Oversea sales blog > 【Echo Tech】 Ultrasonic transducer is a “consumable part”.

【Echo Tech】 Ultrasonic transducer is a “consumable part”.

Ultrasonic cutter could cut plastic like butter, and shorten your worktime.
By keep using ultrasonic cutter, users eventually get use to cut materials faster and try to do more faster by adjusting to high power mode.

However, we would like all users to know that ultrasonic transducer is a “consumable part”.
Which means, if you keep overload on ultrasonic cutter, transducer will deteriorate faster.

「OUT OF ORDER」のイラスト文字

High power mode.

(Installed power mode)
ZO-91 model/ Normal・High

ZO-95 model/ Normal・High・S-High

To keep use unit longer, please use Normal mode for general use.
When you need a power at particular works, High・S-High modes are timing to use. Using High and S-High modes will make faster deteriorate transducer.

Overload on Hand piece.

ZO-91 and ZO-95 has installed our company’s original “TAF” circuit. This circuit enhances cutter’s sharpness when it detects power applied on hand piece. It supports to cut hard materials within lower power mode, but when it works too much, it also makes faster deterioration on transducer.

To use well, do not apply too much power on hand piece.
Handle hand piece softly, and when you feel heat on hand piece or main unit, please leave unit until its temperature get normal.

Make contact us anytime for your unit malfunction.

When you feel your unit get fault, please make us contact a.s.a.p.
Keep using faulted unit is dangerous and it might deteriorate much more.
We accept any of your questions or comments!

worldinfo@us-dolphin.co.jp

[mwform_formkey key="2639"]
Contact us