【Echo Tech】 Weakest power, but works finely.
Our ultrasonic cutter ZO series power worse, if it compared to other companies model.
For people who wants to cut large work materials speedily, we recommend you to get other brands cutter, but there are some situations our ZO series(weak power) works better.
Different power level, but same frequency!
Most of ultrasonic cutter sold in market are set its frequency in 40kHz.
(set around 20kHz products are mostly produced for weld or polish work.)
Frequency is not directly connects to sharpness level.
For example, if there are tree that needs 100 times sawing to cut for child, adult could cut tree sawing lesser than child. This is because, body power(voltage) effects more directly for cutting tree, than number they sawed(frequency).
40 kHz has set considered of a point of ultrasonic wave transmission to blade.
Ultrasonic is a “wave” and if it transmitted to blade, vibrated and not vibrated, both points exists on same blade. To bring vibration point on blade edge, 40kHz is a best frequency.
As it mentioned on example of tree, power will change depends on voltage.
Merit of “weak power”(low voltage)
Ultrasonic cutter ZO series are produced 35VA~110VA for power consumption.
As it is lower power, it mostly used by hobby users.
1. Lesser damage for work material
When you want to remove plastic part from metal, it hardly make cutting damage on metal.
Focusing on this feature, sometimes we have order from factory, which they want to make processing on components or products without damaging.
2. Weld and Polish work within single unit!
Ultrasonic cutter ZO series are able to adjust its power level, and those levels range are corresponds to weld and polish.
For small demands..
In various works exists in this world, the tool demand, and that’s why several types of same tool are produced. Ultrasonic cutter is one of expensive hand tool, so please don’t hesitate to make us contact to find our best model.
Send us any of your questions or comments here.
worldinfo@us-dolphin.co.jp