MENU
HOME > Blog > Oversea sales blog > The case of better changing model ZO-91 to ZO-95.

The case of better changing model ZO-91 to ZO-95.

Hello.

Are you concerning for which Ultrasonic Cutter model to get?

分かれ道で迷う人のイラスト(男性)

Basically, we are suggesting ZO-91 for hobby use, and ZO-95 for worker’s use.
Let’s see what we had inquiry before, from customers of model changing.

 

Q1. We are now using ZO-91 for hobby use, but it seems broken. Should we change model to ZO-95?

A1. If you are using Ultrasonic Cutter every day for a long day, you better to use ZO-95.

Even if the purpose of using was Hobby, Ultrasonic Cutter ZO-91 may defect by using long time and applying power too much. However, if you are just using for cutting plastic, by taking a rest for ZO-91 or do maintenance well, not applying power too much, the unit will run longer.

 

Q2. We are going to use for industrial work, but because ZO-95 is expensive, we would like to get ZO-91. Will something problem happen when we use ZO-91 for industrial work?

A2. We strongly recommend to get ZO-95, but depends on work material and worktime, ZO-91 might be no problem for using.

The reason that we recommend ZO-95 for industrial working is, because it able to use long day and installed S-High mode that applied for hard materials. If you just want to use at point of work on plastic or soft materials, ZO-91 might be enough for using.

 

Q3. We want to use for industrial work and for hobby both. Which model should we get?

A3. We recommend you to get ZO-95.

If you will not use for just single purpose, there may be cases that you cut several types of materials, or using unit long time. For those cases, ZO-95 is applicable.

 

If you are now facing to concern except listed above, please send us message here.

worldinfo@us-dolphin.co.jp

[mwform_formkey key="2639"]
Contact us